Drinkwell Pet Fountain for Cats

Operating InstructionsInspect the bottom of the fountain to be sure the motor is securely attached.Remove the housing cover and insert the filter cartridge down into the well in the housing. It fits in the well diagonally. The bottom of the filter is more narrow than the top and the black side faces outward (towards the spout). If the fit is too tight, it is either in upside down or in the wrong groove at the front (move it back one groove). Rinsing the filter before use will help remove any loose bits of charcoal, which are harmless.Fill the fountain with water (both the bowl and the housing where the filter sits).Place in desired location (if placing on carpet or wood floor, the use of a protective surface is recommended for under the fountain).Make certain the cord and plug are dry, then plug into a polarized outlet (one slot is larger than the other). The plug will only fit into a polarized outlet. Do not attempt to force it into an old unsafe outlet. Use an adapter if necessary. There are notches for the power cord on both sides of the bottom of the fountain. These are a pass-through for the cord. They are not for holding the cord snugly which might damage the cord. The cord should be passed through vertically. Do not turn the cord horizontally and force into a notch as this may damage the cord and create a hazard.To achieve the desired water level, add more water to the bowl after the unit is primed and running.Set the desired flow rate with the flow control knob, which is next to the ramp in the bowl (minimum rate at 11:00 position, maximum rate at 1:00 position).Add water to the bowl as needed (the bowl holds six cups of water). During regular use, do not allow the water level to fall below the inlet grate on the bottom of the flow control knob so that the motor does not run dry.Manufacturer's Safety InstructionsYou may need to place the fountain up off the floor if you have small children or large dogs who may knock it over or drink it dry.While the capacity of the next generation fountain as been increased, it is not recommended that any appliance be left running unattended over several days.Do not allow pets or children to chew on or swallow any parts. If you are concerned about the power cord, purchase a cord conduit (a hard plastic protector) at any hardware store.Standard Safety PrecautionsDo not attempt repairs on the motor yourself. Return it under the cover of the warranty.If the plug of this device gets wet, turn off the electricity to that outlet. Do not attempt to unplug.To avoid the possibility of the plug or outlet getting wet, the outlet should always be above the level of the fountain.Examine this appliance after installation. It should not be plugged in if there is water on the cord or plug.Do not operate any appliance if it has a damaged cord or plug, or if it is malfunctioning or has been damaged.If an extension cord is necessary, a cord with a proper rating should be used.The electrical use of the appliance is six watts.Close supervision is necessary when any appliance is used by or near children.Always unplug any appliance when not in use, before putting on or taking off parts, and before cleaning.Never yank a cord to remove from the outlet plug and pull to disconnect.Do not use appliance for other than intended use. The use of attachments not recommended or sold by the manufacturer may cause an unsafe condition. Do not modify the unit.Do not install or store appliance where it will be exposed to weather or temperatures below freezing.For indoor use only.Read and observe all important notices on the appliance.Important Reminder: As with any electrical device, always check the power cord for damage before use.Notice: The fountain must be disassembled and cleaned, including the motor, to maintain normal function. Lack of cleaning may void the warranty.Complete use and cleaning instructions included.Made in USA.