Installation InstructionsChoose an area that has stationary posts or trees available at both ends of the run areaTrolley system should be installed six feet or higher above the ground. This will allow you to walk under the trolley easily.Drill pilot holes into the posts or trees and install hooks.Attach the spring end of your trolley cable to one of the hooks.Slide one of the stops onto the cable and let it slide loosely. The stops look like washers.Slide the pulley onto the cable.Slide the second stop onto the cable and let it slide loosely.Loop the end of the cable through the other hook and pull it tightly.While holding the cable tight, secure the large netal clamps. Place the first clamp 3" and second clamp 6" from the hook. Tighten the clamps. Any excess cable can be cut off.Select the optimal location for the stops. Place a small metal clamp behind each stop.Tether the dog by attaching the tie-out cable to its collar Warning: This product is intended for pets only. Keep out of reach of children. Do not use this tie out cable with choke type collars or when walking your dog. Never use this tie out cable near or around obstacles in which your pet can become entangled. Not all dogs can be tethered effectively - owner supervision and judgement are required. Dogs known to be aggressive in nature should not be left unattended while on a tie-out cable, trolley or chain. Always remember to provide fresh water for your pet.
PETCO Dog Tie-Out Trolley
PETCO Dog Tie-Out Trolley
PETCO Dog Tie-Out Trolley
